SERIAL COMMAND MATLAB FOR MAC MAC OS X
SERIAL COMMAND MATLAB FOR MAC INSTALL
SERIAL COMMAND MATLAB FOR MAC SERIAL
SERIAL COMMAND MATLAB FOR MAC SOFTWARE

Make sure they agree with the settings that the serial device expects. These are all parameters of the 'serial' object.

SERIAL COMMAND MATLAB FOR MAC SOFTWARE

In my experience, many devices & software react badly to incorrect settings, such as: You might try looking at the serial communications settings. Good luck, post again if it still doesn't work. If you are really motivated, take careful notes while you work on this problem, and then write down *exactly* what you did. Good technical writing takes a lot of work, thats why its a paying job.

Then I would forget it again in a few minutes :) So, instead, I write 'do the cvs update'. If I was going to do it right now, I would read the help file, then google something, then ask somebody, etc., until I got it. For example, while writing this post, I can't remember the syntax for doing a cvs update. Yeah, this is actually really hard, because there are a lot of creative idiots out there, including myself. > For those not very familiar with Terminal and shell scripting this getting stuck story shows up quite often, there's a lot of 'as you'd always do.' written in the instruction texts! Not that I'm complaining about all you great guys working to get around all these problems, but a more 'idiot-proof' version would be welcomed arms wide open! :) You can type 'ls /dev/tty.*' to get a list of connected serial devices. Yes, the port name is the complete entry including '/dev'. Intuition points to '/dev/tty.Dj-SerialPort-1' but since I still have that other problem. > Finally, a perhaps even dumber question, how do I know which 'Port' is the one I'm after? When trying to open serial('IWantThisToCrashPort') it obviously won't find it and trow a list of available ports. Hi M.A., hi Laurens, I'm trying to get this to work, but got stuck with the cvs update! How can I check which version is intalled? I still get that error Laurens mentions, despite having followed the intructions on this site:įor those not very familiar with Terminal and shell scripting this getting stuck story shows up quite often, there's a lot of 'as you'd allways do.' written in the instruction texts! Not that I'm complaining about all you great guys working to get around all these problems, but a more 'idiot-proof' version would be welcomed arms wide open! :)įinally, a perhaps even dumber question, how do I know which 'Port' is the one I'm after? When trying to open serial('IWantThisToCrashPort') it obviously won't find it and trow a list of available ports. Serial Port Object : Serial-/dev/tty.usbserial-PXQDOOHN > io=serial('/dev/tty.usbserial-PXQDOOHN') Voila! You can now use the normal serial port commands, like Lines that cause an error if you are using OS X (lines 56-58). The PL2303 is another popularģ) Start MATLAB, and edit the file serial.m. I am using a Prologix USB-GPIB controller

SERIAL COMMAND MATLAB FOR MAC INSTALL

TheĢ) Install the kernel driver for whatever USB-serial device Get it and then use cvs to get the latest version. The 2.1-7 version is available for download The following steps will enable serialġ) Install the rxtx code, version 2.1-8 or higher (the

SERIAL COMMAND MATLAB FOR MAC MAC OS X

Product, but the Mac OS X code has only recently become goodĮnough to use, and its still a little edgy (but it is Linux is stable enough that MATLAB includes it in their Mac OS X, even though it is not officially supported.įollowing a hint from Peter Meilstrup, I discovered that theĬode that MATLAB uses for serial port access is created by Port devices (through the USB ports) using MATLAB 2007b on I recently discovered that it is possible to access serial

Serial command matlab for mac